Loading... Please wait...

FraudLabs Pro Prevents Fraud for Digital Businesses

Our Newsletter


SaniFlo SANIPACK Macerator Pump

  • SaniPack Macerator
  • SaniPack Installed behind the wall cut away view
  • SaniPack Installed
RRP:
$997.00
Your Price:
$847.45 (You save $149.55)
SKU:
011
Brand:
Availability:
Usually ships in 3. to 5 business days!
Quantity:


Product Description

SaniFlo SANIPACK Macerator Pump

Possible connections

Wall-Hung Toilet Sink
Shower

Vertical and horizontal discharges: 9 Vertical ft  100 Horizontal ft

 

The SaniFlo SaniPack is a macerator device which is meant to be installed inside a wall cavity.  The SaniFlo SaniPack is a system that is used to install a complete bathroom up to 9 feet below the sewer line, or even up to 100 feet away from a soil stack.  It can handle the effluent from a toilet, sink and shower.

The SaniFlo SaniPack is simplicity itself to install; there are just four connections.

  • The SaniFlo macerator/pump is connected to the discharge pipe coming from a wall hung toilet
  • The SaniFlo toilet tank is connected to the water supply
  • The SaniFlo macerator/pump is connected to the small diameter discharge pipe work
  • The SaniFlo macerator/pump is connected to the electrical supply

The inside of the SaniFlo SaniPack is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel macerator blades and the pump.

When the flush is activated, the water flowing into the SaniFlo SaniPack activates a micro switch in the pressure chamber which in turn starts the motor.  The motor is sealed for life in an oil filled enclosure.  A common spindle/shaft drives the impeller and the macerator blades.  The moving parts therefore are kept to an absolute minimum. Water and organic waste matter enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 RPM.  The centrifugal force causes the reduced solids to be ejected through a grill into the container where it is picked up by the impeller pump mounted beneath the motor.  

The SaniFlo SaniPack unit pumps the effluent upward to 9 feet and/or 100 feet horizontally (with gravity fall).  Once the water is discharged and the water level in the container goes down, the micro switch deactivates the unit until the flush is activated again.  A normal operating cycle for Sanipack takes about 7-9 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal. 

In addition to the toilet waste, the SaniFlo SaniPack will also discharge gray water from a variety of other sanitary fixtures such as: a sink, a shower and a urinal. When adding a shower, a base will have to be constructed.  This base should be made out of a 2" x 6" (minimum) or 2” x 8” (recommended) on edge, to allow for the installation of a P-trap and the required 1/4”per foot gravity flow towards the pump unit. 

The wastewater from other sanitary fixtures is discharged into the SaniFlo SaniPack via two 1-1/2 inch inlets on either side of the housing.  Either one or both inlets can be used as required.  The discharge elbow on top of the SaniFlo SaniPack can be turned either to the left, to the right, or towards the back, depending on the discharge installation.  A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit. 

This SaniFlo SaniPack unit has been designed with a vent connection on the lid.  All plumbing codes require connection to a vent system.  Please note that the vent system should be a two-way air vent.  The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems.

It is also highly recommended for the SaniFlo macerator/pump to be connected to a Ground Fault Interrupter (GFI) circuit.

The SaniFlo SaniPack is designed to be used with a wall hung toilet.  The depth of the case allows for this pump to be installed within the wall.  Since the reservoir, the macerating pump and the pipes are hidden from view, this type of installation gives you the lean and clean look of a European bathroom.

The SaniFlo SaniPack has been certified to American and Canadian Standards.  Macerating standard; US: CSA Certified & IAPMO (UPC) listed - ASME A112.3.4, CA: Macerating Standard CSA B45.9.


Warranty Information

Saniflo offers a 2-year warranty for the pumps and a 1-year warranty for the toilet bowl and tank. The warranty starts from the date of purchase.

The warranty is voided when any foreign objects are found in the macerating unit. Pouring automobile anti-freeze, solvents paintings, acids, alkaloids, plastic bags, metal, plastic material, wood or anything that could halt, damage or corrode the unit, voids warranty. The motor is filled with oil and sealed for life at the factory; draining the oil out of the motor voids warranty as well.

Find Similar Products by Category


Write your own product review

Product Reviews

  1. Great Service 5 Star Review

    Posted by on 6th Aug 2012

    I just have to say that Saniflo Systems made it easy to order this pump.

    Great service!



You Recently Viewed...